Trust GReddy Performance Damper Type S - CT9A

Set of pre-owned Trust Greddy Type S Performance Damper for the Mitsubishi Lancer Evolution 7, 8 and 9 (CT9A). This is an advanced monotube designed replacement for the standard components produced in accordance with racing driver Takeshi Tsychiya.

The features are as below:-
- Four Corner, Full Length Adjustable Ride Height With an adjustable threaded base and spring perch height adjustments can be made without sacrificing spring preload or shock stroke. Even with a lower ride height, by maintaining stroke, bottoming out can be prevented, thus maintaining traction even when hitting a dip while corning. In addition, by having both adjustments for the front and rear, it is possible to adjust ride height in millimeter increments if desired.

- 32 way adjustable dampening By using a special 32 way valve needle, compression and rebound dampening can be simultaneously adjusted to suit both street and track use. The precise changes allow for sporty handling while still maintaining a comfortable ride.

- Adjustable Spherical Bearing Upper Mounts (pillow-ball) Standard equipment on vehicles equipped with front struts are adjustable spherical bearing upper mounts. The thick 10mm aluminum upper plates are precisely marked for secure and accurate camber adjustments. While the use of replaceable spherical bearings add extended life and cost effectiveness to the system.

- Mono Tube Shock Design The use of a large 46mm diameter piston in a Mono-tube shock design provides quick reacting dampening, even during low speed driving. While, the construction of the case is not only lightweight, but also designed to be very rigid.

- Strengthened Rubber Bushing Upper Mounts & Billet Aluminum Brackets For non-strut type applications, a thick 33mm strengthened rubber bushings on sturdy 10mm billet aluminum upper mount and lightweight billet aluminum brackets are used. This offers both exceptional noise reduction and very controllable handling profile.

- Lightweight High-grade Coil Springs All systems employ a special high strength steel (SAE9254) in it’s coil spring. This allows the springs to have the optimum balance of precise stroke, durability and lightweight. Rear springs are designed with 250mm (unless listed otherwise) variable springs to maximize the rebound stroke. This inhibits loosing traction when "lifting" while cornering. It also contributes to stable traction in wet or dry road conditions.
The spring rates are Front: 8 kg/mm and Rear: 6 kg/mm

Contact us at for pricing and delivery to your location. 





No comments:

Post a Comment